What would you use it for?

Picture a weekday. The panels are producing while you’re out. By the time you get home and start dinner, there’s much less sunlight. That’s the sort of gap a battery can help with.

A compatible battery stores some surplus solar electricity for later. It won’t store everything, and it won’t necessarily cover the whole evening. That depends on what went into it, its usable capacity, losses and what the house is drawing.

The two numbers to look at.

You’ll see capacity in kilowatt-hours, or kWh. That tells you how much energy the battery can store. Check the usable capacity, because that’s the part available to you.

You’ll also see power in kilowatts, or kW. That tells you how quickly it can supply energy. It matters when several appliances are running at once.

Ask the installer to talk through a normal evening in your house. What could run from the battery, and when would you still be drawing from the grid?

A large storage capacity doesn’t automatically mean a high power output. Both limits need to suit how you expect to use it.

Will it work in a power cut?

Don’t assume so. Backup needs the right equipment and electrical setup. Some battery installations won’t supply the house at all when the grid goes down.

If backup is one of your reasons for buying, make that clear from the start. Ask which circuits would stay on, what you could run and what the limits are. Get that written into the design.

Start with what you’d actually use.

Look at how much spare solar you have and how much electricity you normally use after sunset. Those numbers help you judge whether a proposed battery is a sensible size.

Ask about compatibility with your existing inverter, warranty conditions and how the controls work. If you’re comparing costs, make sure both quotes include the same work.

A battery is an extra purchase. It’s fine to ask for the figures with and without it before deciding.

Further reading: U.S. Department of Energy: solar system design basics. Equipment and local requirements vary. A property-specific assessment is needed for a final design.